Core Technical Specifications
- Curing Speed: Quick-dries in roughly 3 seconds under a direct 365nm–395nm UV light source.
- Volume: 10cc liquid syringe, usually weighing around 22.5 grams.
- Color: Green (matches standard green PCB laminate boards).
- Thermal Resistance: High-temperature threshold up to 105°C; it will not melt or soften during subsequent soldering steps.
- Conductivity: Strictly non-conductive (electrical insulator).
Primary Applications
- Jumper Wire Fixation: Locks down microscopic flying lines or enameled copper jumper wires so they do not snap or short out.
- PCB Mask Repair: Patches scratched, peeling, or damaged solder mask layers on logic boards.
- Component Reinforcement: Anchors delicate structural elements like tail plugs, charging ports, chip corners, and screw posts.
Key Usage Tips
- Unlimited Working Time: The gel will never dry out or harden inside the tube or on your workbench until it is directly hit by UV light.
- Layer Thickness: For thick applications over 1.5mm, cure the glue in thin, incremental layers to prevent an uncured liquid core underneath the surface.
- Dispensing: For ultra-precise micro-soldering work, users frequently pair this syringe with a G25 gauge dispensing needle to control the flow
Reviews
There are no reviews yet.