Key Features
- Insulation Strength: Provides highly effective dielectric strength to isolate broken traces and jumper wires.
- Rapid UV Curing: The acrylic oligomer base dries within a few minutes under a concentrated 365nm UV light source.
- Thermal Resistance: Built to withstand standard soldering temperatures without breaking down or melting.
How to Apply It
- Clean the PCB: Remove all dust, grease, and flux residue from the repair area.
- Apply Jumper Wires: If fixing a broken trace, solder your enameled wire into place first.
- Dispense the Liquid: Squeeze a thin layer of the yellow MG-Y10 paste onto the exposed copper or trace.
- Smooth it Out: Use a small brush, roller, or a piece of clear film to flatten the mask smoothly across the area.
- Cure with UV Light: Shine a UV lamp directly onto the mask for 1 to 3 minutes until it becomes completely rock-hard.
- Wipe Clean: Use isopropyl alcohol or a solvent wipe to clean away any uncured excess paste.
Reviews
There are no reviews yet.