Key Specifications
-
- Model Number: CP-2015
- Width: 2.0 mm (optimal for medium-sized solder joints, IC pins, and precision PCBs)
- Length: Typically 1.5 meters (approx. 5 feet) per dispenser spool
- Material: Pure braided copper wire coated with special RMA flux
- Safety Ratings: Electrostatic Discharge (ESD) safe and RoHS compliant
Why This Product Is Chosen
-
- Lead-Free Optimization: Specifically engineered to withstand the high heating loads required for lead-free solder removal.
- Thermal Response: The flat-braid geometry allows rapid heat transfer from the soldering iron, lowering the risk of thermal damage to sensitive PCB pads.
- Clean Absorption: The embedded non-chlorine flux forces molten solder to instantly wick into the braid without leaving caustic residues.
Step-by-Step Usage Instructions
- Placement: Lay the fresh section of the 2.0mm copper braid directly over the solder joint you want to clean.
- Heating: Press a hot, clean soldering iron tip directly onto the top of the wick. Hold for no longer than 3–5 seconds to protect the board.
- Wicking: Watch for the solder to melt and immediately get sucked up into the copper weave.
- Removal: Lift both the iron and the saturated wire away from the PCB simultaneously to prevent sticking.
- Trimming: Cut off the used, silvery portion of the braid with flush cutters before moving to the next joint.
Reviews
There are no reviews yet.